WELCOME!


It is hard to believe that it was almost ten years ago I witnessed a CNC router in action for the very first time. I was fascinated with what I saw and simply had to have one! Although I had been in the creative end of the three dimensional sign business for most of my life I didn't really know what I would do with one - but I just knew it could do fantastic stuff.

Through extensive research and LOTS of hands-on practice I quickly found out that my MultiCam router was capable of just about anything imaginable.This journal will chronicle that journey to date and continue each week with two or three entries as I continue to explore just what is possible with this wonderful tool... -dan

Thursday, August 23, 2012

NEW JERSEY Sign MAGIC Workshop

We get lots of enquiries regarding workshops away from our studio - especially from the folks on the eastern seaboard. They would rather I travel to them than they come all the way out west. Occasionally I do just that and thanks to the folks at MultiCam East just such an opportunity has again presented itself.


A Sign Magic Workshop is to be held in at the MultiCam East Technical Center, Hackensack, New Jersey on Tuesday, Wednesday and Thursday, November 6, 7 and 8, 2012.  Seating is limited.


Multicam East
61 Voorhis Lane
Hackensack, NJ 07601



For information contact Jeff Goldberg
jeff@multicameast.com

Jeffrey Goldberg
707 N. Howard Street
Baltimore, MD 21201
410-728-6000
410-728-4822  (fax)

The Sign Magic Workshop is also being presented in part by EnRoute Software, Coastal Enterprises (Precision Board) and Abracadabra Sculpting Epoxy.