It is hard to believe that it was almost ten years ago I witnessed a CNC router in action for the very first time. I was fascinated with what I saw and simply had to have one! Although I had been in the creative end of the three dimensional sign business for most of my life I didn't really know what I would do with one - but I just knew it could do fantastic stuff.

Through extensive research and LOTS of hands-on practice I quickly found out that my MultiCam router was capable of just about anything imaginable.This journal will chronicle that journey to date and continue each week with two or three entries as I continue to explore just what is possible with this wonderful tool... -dan

Monday, November 3, 2014

Well hung

Once the pieces had all been routed it was time to the glue up. We used the routed slots in the center of the sign as a jig to tack up the steel frames, then pulled them out and did the final welding. Some steel eye bolts were also welded to the top of the frame. A 5/8" steel bar was welded to the post side of the sign as well. The sign was hung from the matching eye bolts on the structural steel post. Then we welded the 5/8" steel rod to the post on the bottom to keep the sign from swinging should there be a strong wind.

I then used an air powered die grinder to go over the edges to get rid of the glue lines and add a little texture. The faxes of the sign got a little of the treatment at the same time.

Tomorrow we'll begin my favorite part - the hand sculpting of Pike, the engineer. Stay tuned...