In the next few posts I'll try and answer those questions. Since the projects are still underway the answers may come out in dribbles as I can take the pictures to show what I'm taking about.
One of the questions I fielded this week concerned how we attached the lath to the welded pencil rod frame. The answer is simple. We use rebar tie wire and end nippers.
A loop is formed and it is pushed through the mesh, then the short end is pulled back through again around the pencil rod.
Using end nippers, it is grabbed, tightened, twisted and cut off in one smooth motion. It takes practice to get good and fast. The key is to pull the wire tight with your left hand and grip it close to the steel bar.
When you twist it everything should snug up fast and after only a bit more than a 90 degree twist you can cut it off. As I said it is easier said than done. Keep the Bandaids handy as the metal ends are all sharp... real sharp. Ask me how I know. :)
If you look close you can see the neat rebar wire tie in the center of the picture. You want to put enough ties on your piece to keep things nice and secure... but no more than that or you will just waste time, and bandaids if you aren't careful.
I hope this helps explain the first bunch of questions I received this week...
-dan
